Labconco Procedure Station 31252xxx2

Confirm if the UV lamp is present in the model

Safety and Disposal Instructions

Ensure compliance with local disposal laws for hazardous waste

Consult www.lamprecycle.org for safe handling, recycling, and disposal information

Record the UV lamp hour meter reading

Start the cabinet blower and let it operate for 5 minutes

Raise the sash to its full open position

Disinfect interior surfaces with suitable chemical disinfectant

Wipe down interior surfaces after contact time elapsed with 70% alcohol solution

Wipe down the interior surfaces of the cabinet with a suitable disinfectant or 70% ethanol and allow to dry

Periodically lift the work surface and wipe down the area beneath it

Inspect and clean the towel catch located at the rear of the work area, beneath the work surface

Dispose of rubber gloves appropriately and have lab coat laundered properly

Wash hands and arms thoroughly with germicidal soap

Wipe down cabinet exterior using 70% alcohol solution

Check all service valves for proper operation (if equipped)

Check the UV Lamp Hour meter and note in log (if equipped)

Identify Thrown Circuit Breaker

Check the position of circuit breakers

Is the white barrel of any circuit breaker extended?

Push in the extended white barrel of the thrown circuit breaker

Is power restored to the internal outlets when the Outlet icon is displayed on the Home Screen?

Is power restored to the cabinet when the System Reset Switch is on?

Lift the front edge of the work surface by grasping the knob at either front corner

Is removal of the work surface necessary?

If removing, decontaminate the work surface thoroughly before removing it from the cabinet

Remove the work surface by pulling it straight out, letting the rear edge rest on the center support

If removing the support bracket/prop rod, compress the sides and lift off the drain pan pins

Reinstall the support bracket/prop rod with the arrow facing the front of the cabinet