Labconco Biosafety Cabinets 30262xxx2

Perform the following tests as per NSF/ANSI Standard Number 49

Perform user comfort related tests if necessary

Was the cabinet recertified by a qualified technician?

Notes or observations during certification

Wipe down cabinet exterior using 70% alcohol solution

Check all service valves for proper operation

Check the UV Lamp Hour meter and note the reading in the log

Clean sash glass with suitable glass cleaner

Clean UV lamp with suitable glass cleaner

Enter the Filter Life percentage

Confirm if the UV lamp is present in the model

Safety and Disposal Instructions

Ensure compliance with local disposal laws for hazardous waste

Consult www.lamprecycle.org for safe handling, recycling, and disposal information

Preparation for UV Lamp Replacement

Start the cabinet blower and let it operate for 5 minutes

Raise the sash to its full open position

Thoroughly surface decontaminate the UV lamp and the work area of the cabinet

Disinfect and Wipe Down Interior Surfaces

Disinfect interior surfaces with suitable chemical disinfectant

Wipe down interior surfaces with 70% alcohol solution after contact time elapsed

Wipe down the interior surfaces of the cabinet with a suitable disinfectant or 70% ethanol and allow to dry

Periodically lift the work surface and wipe down the area beneath it

Inspect and clean the towel catch located at the rear of the work area, beneath the work surface

Dispose of rubber gloves appropriately