Labconco Procedure Station 31232xxx2

Lift the front edge of the work surface by grasping the knob at either front corner

Is removal of the work surface necessary?

Reinstall the dished work surface by resting the bottom on the center support and pushing it back into the cabinet

Engage the tabs on the back corners of the work surface with the slots on the rear wall of the work area

Pull the work surface straight out, letting the rear edge rest on the center support underneath

Identify Thrown Circuit Breaker

Check if the internal outlets have power when the Outlet icon is displayed on the Home Screen.

Check if the cabinet has power when the System Reset Switch is on.

Identify the thrown circuit breaker(s)

Locate the circuit breaker with the extended white barrel.

Push the extended white barrel back in to reset the circuit breaker.

Verify if the internal outlets have power after resetting the circuit breaker.

Confirm if the UV lamp is present in the model

Safety and Disposal Instructions

Ensure compliance with local disposal laws for hazardous waste

Consult www.lamprecycle.org for safe handling, recycling, and disposal information

Start the cabinet blower and let it operate for 5 minutes

Raise the sash to its full open position

Wipe down cabinet exterior with 70% alcohol solution

Check all service valves for proper operation

Enter the UV Lamp Hour meter reading

Note any observations in the log

Perform the following tests as per NSF/ANSI Standard Number 49

Perform user comfort related tests if necessary

Was the cabinet recertified by a qualified technician?

Comments or observations from the certifier