Novexx Solutions Label Printer XLP 504

Switch off the device and disconnect the mains power connecting line.

Ensure no liquid enters the machine.

Avoid using spray bottles or sprays directly on the machine.

Repairs must only be made by trained service technicians.

Avoid using sharp cleaning materials that may damage the printer.

Do not use cleaning agents that could damage the paint finish, labelling, or electrical components.

Avoid acid or alkaline solutions.

Ensure all necessary tools are available

Tighten the set screw [104A] in the material guide to increase the driving force

Check the movability of the material guide. If necessary, repeat tightening the set screw [104A]

Refer to the service manual for adjusting the friction according to the factory settings

Switch off the device and disconnect the mains power connecting line

Ensure no liquid enters the machine

Avoid using spray bottles or sprays on the machine

Ensure repairs are only made by trained service technicians

Avoid using sharp cleaning materials

Do not use cleaning agents that could damage the paint finish, labelling, display, type plates, or electrical components

Avoid scouring cleaning agents or those that could dissolve plastic

Switch off the device before cleaning or maintenance and pull out the mains power connecting line!

Ensure no liquid gets into the machine

Avoid using spray bottles or sprays directly on the machine

Repairs must only be made by trained service technicians

Use a cloth wetted with cleaning agent to clean the machine

Avoid sharp cleaning materials that may damage the printer

Do not use cleaning agents that could damage the paint finish, labelling, display, type plates, or electrical components

Switch off the device and disconnect from the power.

Ensure no liquid enters the machine.

Avoid using spray bottles or sprays on the machine.

Ensure repairs are conducted by trained service technicians.

Ensure the print head has cooled down before cleaning.

Switch off the printer and disconnect from the power.

Open the print head pressure lever.