Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Mori Seiki CNC Turning Center NL2500/700

Create an account to install this asset package.

Maintenance Plans for Mori Seiki CNC Turning Center Model NL2500/700

Integrate maintenance plans directly into your work orders in MaintainX.

2000 Hourly Hydraulic Unit Oil Replacement

11 HYDRAULIC UNIT

11-1 Precautions when Performing Maintenance Work

DANGER

Turn OFF the main power.

CAUTION

1. If the oil level decreases rapidly, the pump unit or the machine may be malfunctioning. Contact the Mori Seiki Service Department for assistance.

2. Maintain oil at the correct level to prevent air being suctioned through the pump unit.

3. Keep oil free from contamination.

4. If foreign matter accumulates in the tank, oil cannot be kept free from contamination, causing pump damage.

Run this procedure

Coolant Discharge Rate Adjustment

WARNING: Disregarding the following warnings will result in serious injuries and machine damage by fire. Mori Seiki is not responsible for accidents and fires arising from disregard for the warnings.

Is the coolant non-flammable?

Is the operation unmanned?

Is automatic fire extinguishing equipment installed?

Is the coolant cooling unit installed?

Is the coolant viscosity appropriate?

Have you received the MSDS (MATERIAL SAFETY DATA SHEET) from the coolant manufacturer?

CAUTION: Use coolant that satisfies the following conditions.

Select the properties of the coolant

Run this procedure

Initial 2 Months Chip Conveyor Belt Adjustment

WARNING: Turn OFF the main power. [Entanglement of hands or feet, serious injury]

Main power turned OFF

Drive cover removed

Parts A removed

Lock nut loosened

Tension in the belt adjusted by rotating the adjusting bolt

NOTE: Adjust the tension of the belt and make the gap between the side wing and wing guide even on either side (Figure B).

Lock nut tightened to secure the adjusting bolt

Belt pushed up with your hand in the direction C from the lower side of the discharge section

Run this procedure

Coolant Gun Cleaning

10 COOLANT UNIT

10-10 Coolant Gun (Option)

Cleaning Coolant Gun

Remove the nozzle head and remove chips and foreign matters.

CAUTION

Do not touch chips with bear hands. If handling chips, wear gloves that have resistance to cutting.

[Injury];

Run this procedure

1500 Hourly Coolant Tank Cleaning

19 HIGH PRESSURE COOLANT UNIT (OPTION)

WARNING

1. Do not operate the high pressure coolant unit or perform maintenance and inspections without reading and obtaining a thorough understanding of the contents of the operation manual provided with the high pressure coolant unit.

2. Keep the high pressure coolant unit operation manual on hand to enable immediate reference.

3. After the completion of the maintenance and inspections, remount all covers before running the machine.

19-4 Cleaning Coolant Tank

1) Remove the separator cover of the clean tank and the dirty tank.

WARNING

Run this procedure