Hyundai Forklift 50DF-7

Air cleaner element. Check, Clean

Blow dry compressed air(Max 30psi) from inside along pleats. Next blow air form outside along pleats, then blow from inside again and check element.

If there is grease or carbon on the element, use a special element cleaner, following the instruction given with the cleaner. Have a spare element ready so that the machine can start working again immediately.

Keep clean condition for the air cleaner element all the times.

A dirty air cleaner could be decreased output power of the engine at worst and it also will be caused to increase fuel consumption and black smoke.

Engine oil and oil filter check

Lift chain check and lubrication

Mast roller check and lubrication

Lift cylinder rod end check and lubrication

Lift cylinder tube end check and lubrication

Tilt cylinder rod end check and lubrication

Tilt cylinder tube end check and lubrication

Truck for obvious damage and leaks

Warning plates and decals condition

Lift chain and fastener condition

Change oil after removing drain plug.

Add oil until it just begins to flow out of the oil level.

Dispose of used oil in locally approved manner.

2 When changing oil, remove strainer and clean it with flushing oil.

OSHA approved eye protection rated for 200kPa(30psi) is required for air cleaning operation.

Blow dry compressed air from the inside of strainer to outside and install when completely dry.

Warning: This inspection requires trained personnel with PPE!

Any visible damage or maintenance problems?

Any unusual noises or problems?

Is the truck in need of repair?

Is the truck in an unsafe condition?

Are all capacity, safety, and warning plates or decals attached and legible?

Any leaking fuel, engine coolant, transmission fluid, etc.?

Any hydraulic oil leaks and loose fittings?