Huvitz Chart Projector CCP-3100

Battery Removal and Replacement

Remove the battery cover of the remote controller

Replace the batteries and the battery cover to the remote controller

Did you observe the polarity marks (plus + & minus -) inside the battery compartment?

Will the equipment be unused for an extended period?

Remove the batteries if the equipment is not likely to be used for some time

Describe the local governing ordinances and recycling plans regarding disposal or recycling of device components

Wipe the cover and the screen with a dry soft cloth when they get dirty.

Wipe the projector clean with a damp lint-free cloth and mild detergent if it becomes soiled.

Wipe the lens with a dry soft cloth when it is dirty.

Ensure all parts are dry and free from detergent residue.

Check that the projector is functioning properly after cleaning.

Pull out the plastic cover at the lower part of power socket

Ensure hands are dry before touching the projector

Ensure hands are dry before starting the procedure

Ensure the lamp is cool before touching it

Turn off power and disconnect the power cord

Wait for the projector to cool down for 5 minutes

Use a 2.5mm Allen wrench to remove the two screws from the bottom front of the projector cover

Press the button at the rear of the projector and remove the top cover