Hussmann Island and Multi-deck Island RI1

Long life and satisfactory performance of any equipment is dependent upon the care it receives. To ensure long life, proper sanitation and minimum maintenance costs, these merchandisers should be thoroughly cleaned, all debris removed and the interiors washed down, weekly.

Allow the case to cool for at least 45 minutes before cleaning.

ALWAYS SHUT POWER OFF DURING CLEANING PROCESS.

Fans should be shut off at the source. All deck pans and air grilles are removable.

Coil fins are sharp and pose risk of bodily injury - use extreme care when cleaning around them.

REPLACING FAN MOTORS AND BLADES

WARNING: Always disconnect the electrical power at the main disconnect when servicing or replacing any electrical component.

Remove bottom display racks and deck pans.

Disconnect fan from wiring harness.

Lift fan plenum and remove screws holding bottom of motor to fan basket.

Warning: Always disconnect the electrical power at the main disconnect when servicing or replacing any electrical component.

Fluorescent lamps have shatterproof protective coating?

The switch in the canopy operates both the canopy and the shelf lamps. The rail lamp switch is located on the rail.

Is the main power disconnected?

Upload a photo of the replaced lamp

Sign off on the lamp replacement

CLEANING CENTER AIR DISCHARGE (CAD) TOWER

The interior of the CAD tower must be cleaned at least monthly. Frequency is dependent on the ambient conditions of the store.

DISCONNECT THE ELECTRICAL POWER TO THE MERCHANDISER.

Apply compressed air to the moiré (pattern of slots) of the CAD to blow accumulated dust off the internal baffles.

Use a soft cloth to wipe down the interior. A mild detergent and sanitizing solution may be used. Do not introduce excess water.

Once operating temperature is reached, return product from cooler.

If air cleaning is not done at least monthly, Hussmann recommends washing by a technician at least every 4 months.

Warning: Mirrors are sheets of clear glass that have very thin reflective and protective coatings applied to one side. These coatings are susceptible to deterioration if certain cleaning solutions and even water are allowed to come in contact with them.

Every precaution should be taken to keep all liquids away from the coated side of the mirrors.

IF LIQUIDS ARE ALLOWED TO FLOW ALONG THE FACE SIDE OF THE MIRROR TO ITS EDGE, THE LIQUID CAN SEEP UP BETWEEN THE COATING AND THE GLASS, CAUSING SERIOUS DAMAGE.

To Help Prolong the Life of the Mirrors:

Use only mild glass cleaning products or a weak solution of vinegar and water.

Do NOT spray liquids on the mirrors. Dampen the cleaning cloth, then use the cloth to wipe the mirror.

Wipe water from the mirrors immediately to prevent difficult to remove water spots and also to prevent the water from reaching the mirror's edge.

Never use dirty cloths, scrapers or any other abrasive materials for cleaning.

Sign off on the mirror cleaning