Hussmann Island and Multi-deck Island RI2N

Warning: Disconnect the electrical power to the merchandiser before starting the cleaning process

Electrical power to the merchandiser disconnected

Compressed air applied to the moiré of the CAD

Interior wiped down with a soft cloth

Was a mild detergent and sanitizing solution used?

Power to merchandiser turned on

DO NOT USE AMMONIA-BASED PRODUCTS TO CLEAN ACRYLIC PARTS. NEVER USE ABRASIVE CLEANSERS OR SCOURING PADS.

Clean with nonabrasive detergent and lukewarm water, using the bare hand to feel and dislodge any caked-on dirt. A soft, grit-free cloth, sponge or chamois may be used, but only as a means of carrying the water to the plastic.

Dry with a clean damp chamois or clean soft cloth such as cotton flannel. Do not use hard, rough cloth or paper towels as they will scratch the acrylic.

Wax should be applied in a thin even coat, and brought to a high polish by rubbing lightly with a clean, dry soft cloth, such as a cotton flannel.

Excessive rubbing may cause scratching and/or build up an electrostatic charge which attracts contaminants. Remove an electrostatic charge by blotting with a clean damp cloth.

Warning: This procedure should be performed by a trained technician only to prevent damage to the coil or electrical components.

Electrical power to the merchandiser disconnected?

Shelves, display racks, deck pans, CAD gusset, and canopy light channel removed?

Panels attached to CAD tower removed?

Waste outlets verified open and drip piping not blocked? Loose debris removed?

Unpressurized stream of water used to wash baffles in the CAD tower? Water not introduced faster than drain can handle?

Coil and fans cleaned as necessary?

All surfaces clean and dry, reassembled in reverse order?

Allow the case to cool for at least 45 minutes before cleaning.

WARNING: ALWAYS SHUT POWER OFF DURING CLEANING PROCESS.

CAUTION: Coil fins are sharp and pose risk of bodily injury - use extreme care when cleaning around them.

Exterior surfaces cleaned with a mild detergent and warm water

Interior surfaces cleaned with appropriate detergents and sanitizing solutions

WARNING: Do NOT allow product to sit in a non-refrigerated area.

Warning: Always disconnect the electrical power at the main disconnect when servicing or replacing any electrical component.

IMPORTANT: Always replace lamp holders and end caps with Hussmann lamp holders.

Did you disconnect the electrical power?

Did you use Hussmann lamp holders for replacement?

Upload a photo of the replaced lamp holder

Sign off on the lamp holder replacement