Greenheck Fume Exhaust Fan FJC-306

Ensure the unit is attached to the designed system

Is the wheel rotation in the same direction as the airflow at the outlet?

Does the wheel rotation conform to the rotation decal affixed to the unit?

Describe any issues noted during the check

Check all fasteners and set screws for tightness

Rotate the fan wheel by hand to ensure no parts are rubbing

Access the wheel through the bolted panel on the side of the fan housing

Ensure proper wheel settings for radial gap and alignment

Refer to Radial Gap, Overlap and Wheel Alignment section on page 11 for guidance

Is the fan assembly in working order?

Describe any issues found during inspection

Check for wear, tension, alignment, and dirt accumulation on V-belt drives

Are the belts excessively loose or tight?

Is there any fan vibration due to belt tension?

Are all belts being replaced with a matched set?

Loosen belt tension to remove belts without prying

Ensure slack in each belt is on the same side of the drive after replacement

Inspection and Maintenance Record

Record inspection and maintenance performed

Check for moisture or dirt accumulations on parts

Describe the source of moisture or dirt if found

Purge grease before putting fan into service

Ensure precautions to prevent deterioration during storage

Acknowledge responsibility for fan and accessories during storage