Conair Thermolator Temperature Control Unit CC-12kW-230V

Disconnect and lockout the main power

Shut off the cooling water infeed and drain the unit

Drain all water using the drain plugs located at the bottom of the unit

Inspection of Cooling and Process Lines

Inspect all plumbing lines for leaks

Is there any leak detected in the lines?

Stop the Thermolator if a leak is detected

Describe the location and nature of the leak

Inspection of Power Cords, Wires, and Electrical Connections

Check the ground wire and thermocouple connections

Replace any wire that appears damaged or has worn or cracked insulation

Power Disconnection and Lockout

Remove the top panel of the Thermolator

Use a 1/4-inch open-end wrench to remove the three bolts holding the cap to the heater tank

Disconnect and lock out main power to the unit

Close the electrical enclosure and restore power to the unit

Press any button to display the first test menu