BINDER Incubator BD-S-UL 115

Ensure compliance with applicable regulations (e.g., DGUV guidelines 213-850 for Germany).

Identify the chamber type and corresponding safety controller class

Safety Controller Function Check

Is the safety controller set-point approximately 2 °C to 5 °C above the desired temperature set-point?

Perform a functionality check of the safety controller.

Was an alarm message visually reported during the check?

Describe any issues encountered during the check.

Ensure the following safety measures are in place before starting maintenance

Is the maintenance work being conducted by licensed electricians or authorized experts?

Is the chamber disconnected from power?

Perform regular maintenance work at least once a year

Are the legal requirements met regarding the qualifications of service personnel, scope of testing, and documentation?

Replace the door gasket when cold

Consult BINDER Service for maintenance agreement recommendations

Disconnect the chamber from the power supply

Select cleaning agents for different surfaces

Use the neutral cleaning agent Art. No. 1002-0016 where recommended

Avoid using acidic or chlorine cleaning detergents

Avoid using soapsuds for cleaning

Remove cleaning agents completely from surfaces with a moistened towel

Disconnect the chamber from the power supply by pulling the power plug.

Ensure that decontamination agents do not react with device components or charging material.

Select the decontamination procedure based on contamination type and charging material.

Use adequate personal safety controls during decontamination.

Wear sealed protective goggles to protect eyes from chemical burns.