BINDER Heating Oven ED-S-UL 115

Disconnect the power plug before starting maintenance work

Ensure the chamber does not become wet during maintenance

Verify that maintenance is conducted by licensed electricians or authorized experts

Consult BINDER Service for a maintenance agreement

Is the door gasket cold before replacement?

Disconnect the chamber from the power supply

Remove residues of the charging material from

Wipe surfaces with a moistened towel

Use appropriate cleaning agents for

Avoid using acidic or chlorine cleaning detergents

Avoid using neutral cleaning agent on zinc coated surfaces

Ensure compliance with applicable regulations (e.g., DGUV guidelines 213-850 for Germany).

Identify the chamber type and corresponding safety controller class

Safety Controller Function Check

Is the safety controller functioning properly?

Check if the safety controller alarm message is displayed when the maximum temperature is exceeded.

Temperature Set-point Verification

Enter the current safety controller set-point temperature.

Adjust the safety controller set-point to 2 °C to 5 °C above the desired temperature set-point.

Disconnect the chamber from the power supply by pulling the power plug.

Ensure no decontamination agents that may react with device components are used.

Select the decontamination method based on contamination type and material.

Ensure all inflammable goods are removed before hot air sterilization.

Spray the inner chamber with an appropriate disinfectant.

Ensure the chamber is absolutely dry and ventilated before start-up.