BINDER Incubator FD-S-115 UL

Disconnect the power plug before starting maintenance work.

Ensure the chamber is not wet during operation or maintenance work.

Verify that the rear panel of the chamber is not removed.

Is the maintenance work conducted by licensed electricians or experts authorized by BINDER?

Are the legal requirements met regarding the qualifications of service personnel, scope of testing, and documentation?

Consult BINDER Service for a maintenance agreement.

Ensure compliance with applicable regulations (e.g., DGUV guidelines 213-850 for Germany).

Identify the chamber type and corresponding safety controller class

Safety Controller Function Check

Is the safety controller functioning properly?

Verify the alarm message is displayed when maximum temperature is exceeded.

Temperature Set-point Verification

Enter the current safety controller set-point temperature.

Adjust the safety controller set-point to 2 °C to 5 °C above the desired temperature set-point.

Disconnect the chamber from the power supply

Remove residues of the charging material from

Wipe surfaces with a moistened towel

Use appropriate cleaning agents for

Avoid using acidic or chlorine cleaning detergents

Avoid using neutral cleaning agent on zinc coated surfaces

Disconnect the chamber from the power supply by pulling the power plug.

Ensure no decontamination agents that may react with device components are used.

Select the decontamination procedure based on contamination type.

Wear sealed protective goggles to protect eyes from chemical burns.

Ensure no disinfectant is emptied into drains.