BINDER Heating Oven ED-S 115

Ensure compliance with applicable regulations (e.g., DGUV guidelines 213-850 for Germany).

Verify the chamber type and corresponding safety controller class (2 or 3.1).

Safety Controller Function Check

Check the functionality of the safety controller.

Is the safety controller set-point 2°C to 5°C above the desired temperature set-point?

Visually inspect for any alarm messages indicating a fault.

Did the safety controller maintain control of the chamber temperature?

Disconnect the power plug before starting maintenance work

Ensure the chamber does not become wet during maintenance

Do not remove the rear panel of the chamber

Is the maintenance being conducted by licensed electricians or authorized experts?

Are legal requirements regarding qualifications, scope of testing, and documentation being met?

Consult BINDER Service for a maintenance agreement

Disconnect the chamber from the power supply by pulling the power plug.

Ensure no decontamination agents that may react with device components are used.

Select the decontamination method based on contamination type and material.

Use adequate personal safety controls during decontamination.

Wear sealed protective goggles to protect eyes from chemical burns.

Disconnect the chamber from the power supply

Remove residues of the charging material from

Wipe surfaces with a moistened towel

Use appropriate cleaning agents for

Avoid using acidic or chlorine cleaning detergents

Avoid using neutral cleaning agent on zinc coated surfaces