Baldor Reliance Electric Motor JMM3613T

Storage — Non-Regreaseable Motors

Rotate the motor shaft 15 times to redistribute the grease within the bearing

Rotate ball and roller bearing motor shafts manually

Has the motor been greased in the last 6 months?

Storage — Preparation for Storage

Measure and record the resistance of the winding insulation (dielectric withstand) every 30 days of storage

Place new desiccant inside the vapor bag and re-seal by taping it closed

Place the shell over the motor and secure with lag bolts

Storage — Minimum insulation resistance

Enter the minimum resistance of motor winding insulation

Calculate and record the minimum resistance using the formula Rm = kV + 1

Ensure sleeve bearing (oil lube) motors are drained of oil prior to shipment

Refill oil reservoirs to the indicated level with the specified lubricant

Rotate the shaft by hand for 10 to 15 revolutions to distribute oil to bearing surfaces

Section 3 — Lubrication Procedure

Ensure lubrication is done with the motor stationary and warm

Locate the grease inlet, clean the area, and replace the pipe plug with a grease fitting if necessary

Remove relief plug and clean around it

Is there severe caking at the plug?

Run the motor until the bearing housing is warm if severe caking is present

Locate the motor nameplate and find the recommended lubricant type and volume

Add the recommended volume of lubricant using a hand-operated grease gun

Run the motor for 2 hours with the relief plug removed

Section 3 — Lubrication Procedure

Relubrication with the shaft stationary and a warm motor is recommended

Locate the grease inlet, clean the area and replace the pipe plug with a grease fitting, if the motor is not equipped with grease fittings

Clean caked grease around the plug with a wooden stick or suitable tool

If severe caking appears at the plug, run the motor until the bearing housing is warm

Locate the motor nameplate to find the recommended lubricant type and volume

Add the recommended volume of the recommended lubricant using a hand operated grease gun

Run the motor for 2 hours with relief plug removed