Advantage Temperature Controller SRV-680

Shut down unit operations according to section 3.4 in the manual

Ensure proper lock-out procedures are followed

Ensure system pressure is eliminated and the unit’s pressure gauges read '0' pressure

Drain unit by removing the pump casing drain plug

Remove the capillary connection from the cooling cylinder to the pressure switch

Remove the brass elbow mounted on the pressure switch

Remove the electrical connections to the pressure switch

Shake out the water from the connection

Did the yellow Alert icon disappear?

Stop process operations as described in section 3.4 of the manual

Ensure all process pressure is relieved and pressure gauges read '0' pressure

Drain the unit by removing the pump casing drain plug

Unboxing and Initial Inspection

Unbox the unit before accepting delivery

Document any evident damage on the delivery receipt

Did you refuse the shipment due to damage?

Take photographs of any suspected damage

Inspect the heater contactor for signs of wear or pitting

Is the heater contactor cycling proportionally to the heat input required?

Replace the heater contactor if wear or pitting is observed

Inspect the pump motor starter for signs of wear or pitting

Replace the pump motor starter if wear or pitting is observed

Ensure all components are not overheating

Disengage process operations and relieve all system pressure.

Disengage main power supply and verify the Power light on the display is 'off'.

Remove the lift-off access panel and set aside.

Remove the necessary panels to gain access to the pump motor.

Drain machine by removing the pump casing drain plug.

Remove the three motor wire leads from the motor wiring terminals and map the wire terminal locations.