Advantage Temperature Controller SRV-1675

Disengage process operations and relieve all system pressure.

Disengage main power supply and verify the Power light on the display is 'off'.

Remove the lift-off access panel and set aside.

Remove the necessary panels to gain access to the pump motor.

Drain machine by removing the pump casing drain plug.

Remove the three motor wire leads from the motor wiring terminals and map the wire terminal locations.

Inspect heater contactor for signs of wear or pitting

Is the heater contactor in good condition?

Inspect pump motor starter for signs of wear or pitting

Is the pump motor starter in good condition?

Ensure all power sources are turned off before inspection

Wear appropriate personal protective equipment (PPE)

Shake out the water from the connection

Did the yellow Alert icon disappear?

Stop process operations as described in section 3.4 of the manual

Ensure all process pressure is relieved and pressure gauges read '0' pressure

Drain the unit by removing the pump casing drain plug

Disengage process operations according to the procedure outlined in section 3.4.

Ensure coolant pressure gauge reads '0'.

Disengage main power supply following all lockout/tagout procedures.

Remove or open any access cover panel and set aside to gain access to the make-up solenoid valve.

Remove the 4 retaining screws to disassemble the solenoid valve.

Unboxing and Initial Inspection

Unbox the unit before accepting delivery

Document any evident damage on the delivery receipt

Did you refuse the shipment due to damage?

Upload photographs of any suspected damage