Advantage Temperature Controller SRG-1035

Shut down unit operations according to section 3.4 in the manual

Ensure proper lock-out procedures are followed

Is the system pressure eliminated and the unit’s pressure gauges reading '0' pressure?

Drain unit by removing the pump casing drain plug

Remove the capillary connection from the cooling cylinder to the pressure switch

Remove the brass elbow mounted on the pressure switch

Remove the electrical connections to the pressure switch

Disengage process operations and relieve all system pressure.

Disengage main power supply and verify the Power light on the display is 'off'.

Remove the lift-off access panel and set aside.

Remove the necessary panels to gain access to the pump motor.

Drain machine by removing the pump casing drain plug.

Remove the three motor wire leads from the motor wiring terminals and map the wire terminal locations.

Ensure all necessary equipment is available

Disengage process operations according to the unit manual

Remove the 'to process' temperature probe and insert a ½” plug

Prepare an ice bath and place a digital thermometer in it

Place the probe in the ice bath

Consult with Advantage Service Department to determine if unit can be converted. Record details of the consultation.

Enter the Serial Number of the unit.

Call 317-887-0729 for consultation.

Consult factory for other power conversions if needed.

Items Requiring Replacement or Rewiring

Identify items for replacement or rewiring

Inspect the heater contactor for signs of wear or pitting

Is the heater contactor cycling frequently?

Replace the heater contactor if wear or pitting is observed

Inspect the pump motor starter for signs of wear or pitting

Replace the pump motor starter if wear or pitting is observed

Ensure all components are properly reassembled