Advantage Temperature Controller SRG-1075

Unboxing and Initial Inspection

Unbox the unit before accepting delivery

Take photographs of any suspected damage

Describe the suspected damage in detail

Follow proper procedures for damage claims

Keep detailed records of the damage and claims process

Disengage process operations and relieve all system pressure.

Disengage main power supply and verify the Power light on the display is 'off'.

Remove the lift-off access panel and set aside.

Remove the necessary panels to gain access to the pump motor.

Drain machine by removing the pump casing drain plug.

Remove the three motor wire leads from the motor wiring terminals and map the wire terminal locations.

Inspect heater contactor for signs of wear or pitting

Is the heater contactor in good condition?

Inspect pump motor starter for signs of wear or pitting

Is the pump motor starter in good condition?

Ensure all power sources are turned off before inspection

Wear appropriate personal protective equipment (PPE)

Shut down unit operations according to section 3.4 in the manual

Ensure proper lock-out procedures are followed

Is the system pressure eliminated and the unit’s pressure gauges reading '0' pressure?

Drain unit by removing the pump casing drain plug

Remove the capillary connection from the cooling cylinder to the pressure switch

Remove the brass elbow mounted on the pressure switch

Remove the electrical connections to the pressure switch

Ensure all necessary equipment is available

Disengage process operations according to the unit manual

Remove the 'to process' temperature probe and insert a ½” plug

Prepare an ice bath and place a digital thermometer in it

Place the probe in the ice bath