Advantage Temperature Control Unit SK-675

Disengage operations and ensure all system pressure is relieved.

Verify that the unit's pressure gauges read "0".

Verify the Power light on the display is "off".

Remove the lift-off access panel and set aside.

Drain machine by removing the pump casing drain plug.

Disengage process operations according to the procedure outlined in section 3.4

Ensure all system pressure is relieved and the unit's pressure gauges read '0'

Verify the Power light on the display is 'off'

Remove the thermoformed front panel and set aside

Open the hinged electrical cabinet panel cover

Unplug the sensor probe connection

Shake out water from the service connection

Replug the sensor probe connection

Did the error display change to Solid Red?

Press the Start push button to clear the error display

Cease process operations as outlined in section 3.4 of the manual

Is all process pressure relieved and do the unit's pressure gauges read '0' pressure?

Disengage process operations and relieve all system pressure.

Verify the Power light on the display is 'off'.

Remove the lift-off access panel and set aside.

Remove the thermoformed panel attached by 4 small screws.

Drain machine by removing the pump casing drain plug.

Disengage process operations and verify all system pressure is relieved and the unit's pressure gauges read '0'.

Disengage main power supply and follow proper lock-out procedures.

Verify the Power light on the display is 'off'.

Remove the lift-off access panel and set aside.

Remove the thermoformed front panel and open the electrical cabinet panel door.

Unplug the instrument connectors to fully extend the hinged panel.