Advantage Temperature Controller SRV-1620

Unboxing and Initial Inspection

Unbox the unit before accepting delivery

Take photographs of any suspected damage

Describe the suspected damage in detail

Follow proper procedures for damage claims

Keep detailed records of the damage and claims process

Inspect the heater contactor for signs of wear or pitting on the contacts.

Is the heater contactor cycling proportionally to the heat input required?

Replace the heater contactor if wear or pitting is observed.

Inspect the pump motor starter for signs of wear or pitting on the contacts.

Replace the pump motor starter if wear or pitting is observed.

Ensure all components are not overheating.

Disengage operations and ensure all system pressure is relieved

Verify the unit’s pressure gauges read '0'

Verify the Power light on the display is 'off'

Remove the lift-off access panel and set aside

Drain machine by removing the pump casing drain plug

Shut down unit operations according to section 3.4 in the manual

Ensure proper lock-out procedures are followed

Is the system pressure eliminated and the unit’s pressure gauges reading '0' pressure?

Drain unit by removing the pump casing drain plug

Remove the capillary connection from the cooling cylinder to the pressure switch

Remove the brass elbow mounted on the pressure switch

Remove the electrical connections to the pressure switch

Disengage process operations according to the procedure outlined in section 3.4.

Ensure coolant pressure gauge reads '0'.

Follow all lockout/tagout procedures.

Remove or open any access cover panel and set aside.