Advantage Temperature Controller SRV-1035

Shake out the water from the connection

Did the yellow Alert icon disappear?

Stop process operations as described in section 3.4 of the manual

Ensure all process pressure is relieved and pressure gauges read '0' pressure

Drain the unit by removing the pump casing drain plug

Consult with Advantage Service Department to determine if unit can be converted. Record details of the consultation.

Enter the Serial Number of the unit.

Call 317-887-0729 for consultation.

Select the conversion type for motors and heaters

Consult factory for other power conversions and record details.

Items Requiring Replacement or Rewiring

Identify items requiring replacement or rewiring

Disengage operations and ensure all system pressure is relieved

Verify the unit’s pressure gauges read '0'

Verify the Power light on the display is 'off'

Remove the lift-off access panel and set aside

Drain machine by removing the pump casing drain plug

Inspect the heater contactor for signs of wear or pitting on the contacts.

Is the heater contactor cycling proportionally to the heat input required?

Replace the heater contactor if wear or pitting is observed.

Inspect the pump motor starter for signs of wear or pitting on the contacts.

Replace the pump motor starter if wear or pitting is observed.

Ensure all components are not overheating.

Shut down unit operations according to section 3.4 in the manual

Ensure proper lock-out procedures are followed

Is the system pressure eliminated and the unit’s pressure gauges reading '0' pressure?

Drain unit by removing the pump casing drain plug

Remove the capillary connection from the cooling cylinder to the pressure switch

Remove the brass elbow mounted on the pressure switch

Remove the electrical connections to the pressure switch