Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Zebra Printer R170Xi

Create an account to install this asset package.

Maintenance Plans for Zebra Printer Model R170Xi

Integrate maintenance plans directly into your work orders in MaintainX.

Transmissive (Media) Sensor Cleaning

Warning: Ensure the machine is turned off and unplugged before cleaning.

CLEAN HEAD NOW message appears?

Select the print mode

Upload a photo of the sensor before cleaning

Air blow cleaning performed?

Upload a photo of the sensor after cleaning

Brush or vacuum cleaning performed?

Upload a photo of the sensor after brush or vacuum cleaning

Sign off on the sensor cleaning

Run this procedure

Cutter Cleaning

Warning: The cutter blade is sharp. Do not touch or rub the blade with your fingers.

Is the cutter not cutting the labels cleanly or jamming with labels?

If the cutter is not functioning properly, follow these steps:

Did you turn off the printer?

Did you unplug the power cord?

Did you clean the stationary cutter blade with a swab and solvent?

If cleaning does not remove label fragments and adhesive, contact an authorized service technician.

Sign off on the cutter cleaning

Run this procedure

Black Mark Sensor Cleaning

Warning: Ensure the machine is turned off before starting the cleaning process

CLEAN HEAD NOW message appears?

Select the print mode

Enter the length of labels used in Direct Thermal Print Mode

Enter the length of ribbon used in Thermal Transfer Print Mode

Air blow cleaning successful?

Sign off on the sensor cleaning

Run this procedure

Media Path Cleaning

Warning: Use solvent for cleaning!

CLEAN HEAD NOW message appears

Select the print mode

Enter the length of labels used in Direct Thermal Print Mode

Enter the length of ribbon used in Thermal Transfer Print Mode

Cleaning completed successfully

Sign off on the media path cleaning

Run this procedure

Fuse Replacement

Warning: Turn the AC power switch off (O) and remove the power cord before performing this procedure.

The printer uses a metric-style fuse (5 × 20 mm IEC) rated at F5A, 250 V. The AC power entry module comes with two approved fuses in the fuse holder: one is in-circuit, and the second is provided as a spare. The end caps of the fuse must bear the certification mark of a known international safety organization.

Fuse holder removed with a small-blade screwdriver or similar tool

Faulty fuse removed and new fuse installed in the in-circuit position

Important: If you use the spare fuse, be sure to order a replacement fuse from an authorized Zebra distributor. The spare fuse should be the exact type and rating as the original in-circuit fuse.

Fuse holder snapped back into the AC power entry module

Power cord reconnected, and printer turned on

Note: If the printer does not power on, an internal component failure may have occurred, and the printer requires servicing by an authorized service technician.

Sign off on the fuse replacement

Run this procedure