Terex Compact Light Tower RL4

Warning: Electrocution hazard. Contact with hot or live circuits may result in death or serious injury. Remove all rings, watches and other jewelry.

Explosion/burn hazard. Batteries contain acid. Avoid spilling or contacting battery acid. Neutralize battery acid spills with baking soda and water. Keep all open flames and sparks away.

Wearing appropriate personal protective equipment including gloves, face shield and long sleeve shirt

Battery cable connections are tight and free of corrosion

Battery hold-down bracket is in place and secure

Note: Adding terminal protectors and a corrosion preventative sealant will help eliminate the corrosion on the battery terminals and cables.

Maintaining the engine coolant at the proper level is essential to engine service life. Improper coolant level will affect the engine’s cooling capability and damage engine components. Daily checks will allow the inspector to identify changes in coolant level that might indicate cooling system problems.

Burn hazard. Beware of hot engine parts and coolant. Contact with hot engine parts and/or coolant may cause severe burns.

Note: Do not remove the radiator cap.

1 Check the fluid level in the coolant recovery tank. Add fluid as needed.

Result: The fluid level should be at the FULL mark.

Refer to the engine manufacturer's operator manual.;

Warning: Check the oil level with the engine off.

Sign off on the engine oil level check

Bodily injury hazard. An over-inflated tire can explode and may cause death or serious injury.

Collision hazard. An excessively worn tire can cause poor handling and continued use could result in tire failure.

Tip-over hazard. Do not use temporary flat tire repair products.

Maintaining the tires and wheels in good condition is essential to safe operation and good performance. Tire and/or wheel failure could result in a machine tip-over. Component damage may also result if problems are not discovered and repaired in a timely fashion.

1 Check the tire surface and sidewalls for cuts, cracks, punctures and uneven or excessive tread wear. Replace the tire if uneven or excessive tread wear is found.

2 Check each wheel for damage, bends and cracks. Replace the wheel if any damage is found.

Note: Tires and wheels must be replaced with tires and wheels of the specifications listed.

3 Check each tire with an air pressure gauge. Add air as needed.

4 Check the torque of each lug nut.;