Terex Forklift TH842C

Read entire Maintenance Procedure Section.

Familiarize yourself with all safety precautions listed in Section 1.

Pay close attention to all safety alert symbols.

Be sure you understand the procedures detailed in this section.

Wear personnel protective equipment.

Move machine to a safe level work place.

Lower boom and support all raised equipment.

Perform "BEFORE SERVICING PROCEDURES" before attempting any of the following checks.

Complete all "DAILY MAINTENANCE" checks prior to this time interval.

Perform "BEFORE OPERATING CHECKS" before attempting any of the following checks.

1) CHECK HYDRAULIC RETURN FILTER (GAUGE):

Raise the boom to the horizontal position.

Extend the boom cylinder fully.

Raise the engine speed to full RPM.

Retract the boom cylinder at full speed.

The Pressure Gauge reading should not read more than 25 PSI. If the reading is more than 25 PSI, the filter element should be changed.

Front axle trunions (4) greased

Middle boom rollers (4) greased

Sign off on the forklift greasing

Perform 'BEFORE SERVICING PROCEDURES' before attempting any of the following checks.

Complete all 'DAILY MAINTENANCE' checks prior to this time interval.

Complete all '50 HOUR MAINTENANCE' checks prior to this time interval.

Complete all '100 HOUR MAINTENANCE' checks prior to this time interval.

Perform 'BEFORE OPERATING CHECKS' before attempting any of the following checks.

Perform "BEFORE SERVICING PROCEDURES" before attempting any of the following checks.

Complete all "DAILY MAINTENANCE" checks prior to this time interval.

Complete all "50 HOUR MAINTENANCE" checks prior to this time interval.

Complete all "100 HOUR MAINTENANCE" checks prior to this time interval.

Complete all "250 HOUR MAINTENANCE" checks prior to this time interval.

Perform "BEFORE OPERATING CHECKS" before attempting any ofthe following checks.

Wipe all the dirt from the area surrounding the filter(s).

Remove the filter(s). Thoroughly clean the gasket sealing surface after filter removal.