Skyjack Telehandlers ZB2044

Ensure there are no loose or missing parts and there is no visible damage.

Ensure all bolts and pins are properly tightened.

Ensure there are no visible cracks in welds or structure and there are no signs of deformation.

Ensure all hoses are properly tightened and there is no evidence of hydraulic leakage.

Chain: Ensure there are no loose or missing parts and there is no visible damage.

Boom Angle Indicator: Ensure all bolts are tight, and there is no visible damage.

Lifting Attachment: Ensure there are no loose or missing parts and there is no visible damage.

- Ensure attachment is properly positioned and secured. (Refer to Section 2.13 of the operating manual for attachments.)

Compartment cover is secure and in proper working order

Visual inspection of hoses and fittings

Visual inspection of fuel filter

Hydraulic pump has no loose or missing parts and no visible damage

All bolts are properly tightened

Check all tire treads and sidewalls for cuts or cracks that expose the cord plies.

Check for punctures, holes, and unusual wear.

Check each wheel rim for damage and cracked welds.

Check each lug nut for proper torque to ensure none are loose.

Check each tire with an air pressure gauge and add air as needed.

Check for punctures or holes. Ensure they do not exceed 1 inch in diameter.

WARNING: Ensure that you maintain three points of contact to mount/dismount the cab.

Enter cab and close door (if equipped).

Sit in the driver’s seat and fasten seat belt.

Using a spotter, adjust the mirrors.

Ensure parking brake is engaged.

Adjust the boom controller console.

Insert key into ignition switch and select “|” on position. The red and amber lights at the top of electronic dash display will illuminate. Once red and amber lights are no longer displayed, and the electronic gauges are visible on the display panel; turn the key to start position.

Allow engine to idle for 30 seconds until low brake pressure light is off.

Push “🔊” horn push-button. Result: Horn should sound.

Rollover and Falling Object Protective Structure (ROPS/FOPS):

- Ensure there is no visible damage.

WARNING: Do not modify, drill or alter the operator’s cab in any way.

- Ensure seat is properly secured with no sign of visible damage.

- Ensure seat belt is working properly with no sign of visible damage.

- Ensure brake and accelerator pedals are secure, no loose or missing parts, no sign of visible damage, and movements are not obstructed.