Okuma Twin Spindle Turning Center LT10-M

Check oil level through the oil level gauges in the hydraulic power unit

Check oil level in the slideway lubricating oil tank

Check oil level in the spindle cooling unit

Check the hydraulic pressure supplied to the turret

Check the hydraulic pressure supplied to the chuck

Check the hydraulic pressure supplied to the tailstock

Supply lubricating oil to the hydraulic chuck master jaws

Sign off on the daily machine service

Change hydraulic oil in the hydraulic power unit

Supply lubricating oil to the chip conveyor

Change the spindle cooling unit oil

Sign off on the 6 monthly machine service

The lubrication delivery to each point is controlled by a metering type distribution valve, so no further adjustment is necessary

Rear of the machine (inside the cover)

Right-hand side of the tailstock

Observe the in/out movement of the shaft to confirm proper oil delivery

If no lubricating oil is delivered, Oil level is low?

Replenish lubricating oil with the same brand

Clean the suction filter every 6 Months

Draw the coolant out of the tank using the pump

Disconnect the cables and hoses from the coolant pump

Pull the chip conveyor to the right until it clears the right-hand side cover, then pull it out to the front of the machine

Remove the chip pan or the chip conveyor

Push the tank until it contacts the front rail

Align the left end of the coolant tank with the left end of the machine side cover

Warning: This procedure requires trained personnel with PPE!

Loosen the six headstock clamping screws

Align the headstock In A direction

Tighten screw and secure tightening screw

This shifts the headstock in the A direction

Align the headstock In B direction

Tighten screw and secure tightening screw