Scotsman Modular Cuber C0322

Remove the ice thickness sensor from the water distributor bracket.

Separate the metal sensor from the plastic insulator-bracket.

Wipe the sensor with diluted ice machine scale remover.

Scrub the plastic insulator-bracket with diluted ice machine scale remover to remove all traces of mineral build up.

Wipe the wire to the bulkhead with diluted ice machine scale remover.

Wash all ice thickness sensor parts with clean water.

Release probes by pushing pins in

Pull down, then lift up to remove probe

Clean all dirt and scale from the housing

Clean entire probe, ensuring circled area is clean

Shut unit off by holding the Off button for 3 seconds

Is the Water Solenoid indicator light ON?

Shut the unit down by holding the Off button for 3 seconds

Unplug the harness connection from the inlet water valve

Test using the controller's indicator lights

Test the controller's curtain switch circuit

Test using the controller's indicator light

Ensure the machine is ready for cleaning

Is the cleaning indicator light on?

Push the Clean button to drain and refill the reservoir

Add nickel safe ice machine scale remover

Did the Sump Empty light switch on?

If Sump Empty light did not switch on, push off, un-snap the Water Level Sensor, lift slightly, then push Clean again