Venture Products Power Broom HB580

Was the tire spindle tube lubricated?

Was the wheel axle bearing lubricated?

Was the rotor bearing lubricated?

Attach the power broom to the power unit

Lower the broom to the ground and place the power unit’s primary SDLA lever in the float position

Remove the 3) 3/8” x 1” carriage bolts and flange nuts (A) from the idler end bracket (B)

Remove the idler end bracket from the main frame bracket

Start the power unit and raise the broom just enough to pull the broom rotor to the left and off the drive hub on the right side hydraulic motor

Pull the idler hub out of the left end of the rotor tube (may require prying)

Install the idler hub into the new broom rotor

Slide the broom rotor onto the drive hub on the hydraulic motor

Install the idler end bracket onto the broom rotor and then lower the broom until the holes in the idler end bracket match up with those in the main frame bracket

Clean the broom to remove any accumulated dust or debris

Inspect the broom as instructed in the daily inspection section of this manual

Test the broom to ensure all components are working properly

Detach the power broom from the power unit

Remove the drive pulley shield (A)

Install the new drive belt over the pulley

Replace the drive pulley shield

Park the power broom on a level surface

Allow time for the hydraulic system to cool, if necessary

Remove the oil fill cap from the top of the oil tank

Check the level of oil in the tank (should be approximately 4” or 10 cm below the top of the fill tube)

Is the hydraulic oil level low?

Add Ventrac HydroTorq XL synthetic hydraulic oil until the proper level is reached