Schneider Electric Pressure Transmitter IAP05S-F

Perform zero adjustment after installation

Has the transmitter output stabilized at the final operating temperature?

Rezero the transmitter output to eliminate zero shifts from position effects

Perform two-point calibration if FoxCalTM is enabled

Ensure the FoxCalTM feature is enabled before starting calibration

Verify that the input pressure accuracy is at least four times better than the transmitter’s reference accuracy specification

Perform calibration at LRV point

Perform calibration at URV point

Is the FoxCalTM feature disabled after URV calibration?

Rezero the transmitter output after stabilization at final operating temperature

Ensure PV is in square root mode

Access PV Flow URV function from Device Setup > Full Configuration > Edit Parameters

Perform two-point calibration if FoxCalTM is enabled

Rezero the transmitter output once stabilized at final operating temperature

Check underrange and overrange output values to ensure they extend beyond 4 and 20 mA

Zero Reading Check (DP Transmitters Only)

Verify required tools are available

Remove the device from online operation

Override the milliamp output to the High Failsafe setting of 21.0 mA

Confirm the mA output corresponds to 21.0 mA using the milliamp meter

Override the milliamp output to the Low Failsafe setting of 3.6 mA

Confirm the mA output corresponds to 3.6 mA using the milliamp meter

Return the device to normal operation

Access the transmitter’s top level menu

Navigate to TST DSP and initiate the test

Step through the five test patterns