Schneider Electric Pressure Transmitter IGP05S-F

Ensure the transmitter is in linear mode for DP transmitters

Is the FoxCalTM feature enabled?

Reranging without Pressure Application

Select RERANGE function on the LCD

Enter new LRV value in pressure units

Enter new URV value in pressure units

Reranging with Pressure Application

Apply minimum pressure corresponding to new LRV

Access the transmitter’s top level menu

Navigate to TST DSP and initiate the test

Step through the five test patterns

Is the FoxCalTM feature enabled?

Rezero the transmitter output once it has stabilized at the final operating temperature.

Perform a two-point calibration if FoxCalTM is enabled.

Check underrange and overrange output values to ensure they extend beyond 4 and 20 mA, respectively.

Is the transmitter operating in square root mode?

Return the output to linear mode for zero reading check.

Is the FoxCalTM feature enabled?

Perform One-Point Calibration at LRV

Perform one-point offset calibration at LRV

Is the transmitter output stabilized at the final operating temperature?

Rezero the transmitter output if necessary

Are underrange and overrange output values extending beyond 4 and 20 mA?

Ensure you have the following tools

Follow the required protocol to remove the device from online operation

Override the milliamp output to the High Failsafe setting of 21.0 mA

Use the milliamp meter to confirm that the mA output corresponds to 21.0 mA

Override the milliamp output to the Low Failsafe setting of 3.6 mA

Use the milliamp meter to confirm that the mA output corresponds to 3.6 mA