Schneider Electric Pressure Transmitter IGP05S-T

Is the FoxCalTM feature enabled?

Rezero the transmitter output once it has stabilized at the final operating temperature.

Perform a two-point calibration if FoxCalTM is enabled.

Check underrange and overrange output values to ensure they extend beyond 4 and 20 mA, respectively.

Is the transmitter operating in square root mode?

Return the output to linear mode for zero reading check.

View the total days the transmitter has been in service using the 1 Device Setup > 2 Calibration > Time in Service Meter menu selection.

View the user days since the last reset using the 1 Device Setup > 2 Calibration > Reset User Days menu selection.

Reset the user days to zero if necessary.

Perform a two-point calibration if FoxCalTM is enabled.

Rezero the transmitter output once it has stabilized at the final operating temperature.

Check underrange and overrange output values to ensure they extend beyond 4 and 20 mA, respectively.

Press the NEXT button repeatedly until the display reads CALIB

Press the ENTER button to select CALIB

Apply pressure equal to LRV for CAL LRV method

Ensure zero pressure for CAL AT0 method

Calibrate the lower range value (LRV or 0% range value)

Remove the device from online operation

Perform a minimum two-point sensor calibration check at the 4 to 20 mA lower and upper range points

Verify that the milliamp output corresponds to the applied pressure within the safety accuracy using the reference milliamp meter

Trim the calibration if necessary to match the calibration points

Return the device to normal operation

Document the test results per the requirements of the application

Is the FoxCalTM feature enabled?

Perform One-Point Calibration at LRV

Perform one-point offset calibration at LRV

Is the transmitter output stabilized at the final operating temperature?

Rezero the transmitter output if necessary

Are underrange and overrange output values extending beyond 4 and 20 mA?