Netzsch Pump NM430BO04P24B

Ensure the pump is turned off and isolated from the power supply

Gather necessary tools and replacement bearings

Extract the old bearings from the shaft

Install the new bearings onto the shaft

Ensure the pump and motor are switched off

Remove the fuse to prevent accidental activation

Dismantle the pump for manual cleaning

Clean all pump components thoroughly

Ensure the pump is turned off and isolated from the power source

Gather necessary tools and materials, including SM-Pin Joint Seals and lubricant

Remove old lubricant from pin joints

Inspect pin joints for wear and damage

Are the pin joints in good condition?

Apply new lubricant to the pin joints using SM-Pin Joint Seals

Has the allowable wear limit been reached?

Is stator replacement necessary?

Replace the stator if necessary

Has the conveying product been changed?

Consult manufacturer regarding stator durability for new product

Carry out maintenance according to the drive manufacturer's instructions

Are manufacturer's instructions available?

Drive Unit Maintenance (If no manufacturer's instructions)

Renew the lubricant every 5000 operating hours or at least every two years