Netzsch Pump NM185FS02D12B

Ensure the pump is turned off and isolated from the power source

Gather necessary tools and materials, including SM-Pin Joint Seals and lubricant

Remove old lubricant from pin joints

Inspect pin joints for wear and damage

Are the pin joints in good condition?

Lubricate the pin joints with appropriate lubricant

Is the stator wear within allowable limits?

Has the stator reached the allowable wear limit?

Replace the stator if wear limit is reached

Is the conveying product being exchanged?

Consult manufacturer concerning the durability of the stator for the new product

Ensure the pump and motor are switched off

Remove the fuse to prevent accidental activation

Select the cleaning method used

Was the pump dismantled for cleaning?

Inspect the pump components for sedimentation

Clean all dismantled parts thoroughly

Carry out maintenance according to the drive manufacturer's instructions

If no manufacturer's instructions are available, perform the following maintenance steps

Enter the operating hours since last lubrication

Has it been 5000 operating hours or 2 years since the last lubrication?

Renew the lubricant if 5000 operating hours or 2 years have passed

Are special lubricants specified for the drive?

Check the condition of the joints

Is the sealing in good condition?

Replacement of Seals and Lubricants

Is replacement of seals necessary?

Is replacement of lubricants necessary?

Select the operating time of the pump