Mazak Vertical Machining Center Nexus 530C-II DM

Warning: Do not operate the machine before cleaning

Presence of rust preventive oil on slideways and other machine parts

Upload a photo of the machine before cleaning

Remove rust preventive oil with rag soaked with washing oil

Successful removal of rust preventive oil

Upload a photo of the machine after cleaning

Note: Take care to avoid entry of cleaning oil into the slideway surfaces passing the wiper

Sign off on the initial cleaning of the Vertical Machining Center

WARNING: Always switch off the main power disconnect switch and lock it before carrying out any maintenance work.

Maintenance of electrical equipment must be carried out by qualified licensed electrical engineers only.

When carrying out maintenance in high places, always use a suitable ladder or a service platform and always wear a helmet.

Do not start the machine until all of the covers removed for maintenance have been refitted.

Maintenance work should be carried out by qualified personnel in accordance with the instructions of the person in charge.

Use only the specified grades of hydraulic oil, lubricating oil, and grease or their equivalents.

Follow the instructions on the instruction plate concerning the brands of oil to be used, lubrication points, amount to be used, and oil change intervals.

Stop all machine operation before cleaning the machine or the surrounding area.

Stop the through-spindle coolant and after confirming that coolant does not flow, remove the drain plug to completely empty the filter by draining coolant.

WARNING: Always switch off the main power disconnect switch and lock it before carrying out any maintenance work.

Maintenance of electrical equipment must be carried out by qualified licensed electrical engineers only.

When carrying out maintenance in high places, always use a suitable ladder or a service platform and always wear a helmet.

Do not start the machine until all of the covers removed for maintenance have been refitted.

Maintenance work should be carried out by qualified personnel in accordance with the instructions of the person in charge.

Use only the specified grades of hydraulic oil, lubricating oil, and grease or their equivalents.

Follow the instructions on the instruction plate concerning the brands of oil to be used, lubrication points, amount to be used, and oil change intervals.

Stop all machine operation before cleaning the machine or the surrounding area.

Shut off the power before changing the hydraulic oil.

- Always switch off the main power disconnect switch and lock it before carrying out any maintenance work. This will eliminate the possibility of the machinery being accidentally started by someone else.

- After the power has been switched off for a short while, check the voltage with a multimeter or similar instrument to make sure that there is no residual voltage. Also discharge the capacitors.

- Maintenance of electrical equipment must be carried out by qualified licensed electrical engineers only.

- Do not remove or modify limit switches, proximity switches, or other safety devices.

- When carrying out maintenance in high places, always use a suitable ladder or a service platform and always wear a helmet.

- Always switch off the main power disconnect switch and lock it before replacing bulbs or other electrical equipment, and use products with the same specifications as the original.

- Do not start the machine until all of the covers removed for maintenance have been refitted.

- Wipe up any water or oil spills immediately, and keep the maintenance area and the workplace clean and tidy at all times.

WARNING: Always switch off the main power disconnect switch and lock it before carrying out any maintenance work.

WARNING: Maintenance of electrical equipment must be carried out by qualified licensed electrical engineers only.

WARNING: When carrying out maintenance in high places, always use a suitable ladder or a service platform and always wear a helmet.

WARNING: Do not start the machine until all of the covers removed for maintenance have been refitted.

WARNING: Be absolutely certain to use the specified and standardized parts as replacement or consumable parts.

WARNING: Maintenance work should be carried out by qualified personnel in accordance with the instructions of the person in charge.

WARNING: Do not use compressed air to clean the machine or to remove chips.

WARNING: Use only the specified grades of hydraulic oil, lubricating oil, and grease or their equivalents.

WARNING: When changing a fuse, check that the new fuse has the correct rating.