Toyota Vehicle 4 RUNNER

Perform the following to protect the vehicle and maintain it in prime condition:

l Working from top to bottom, liberally apply water to the vehicle body, wheel wells and underside of the vehicle to remove any dirt and dust.

l Wash the vehicle body using a sponge or soft cloth, such as a chamois.

l For hard-to-remove marks, use car wash soap and rinse thoroughly with water.

l Wax the vehicle when the waterproof coating deteriorates.

If water does not bead on a clean surface, apply wax when the vehicle body is cool.

Fold the mirrors and remove the detachable pole antenna before washing the vehicle. Start washing from the front of the vehicle. Make sure to re-install the antenna and extend the mirrors before driving.

Warning: The reservoir may be hot. Handle with care.

Vehicle has been driven around 50 mph (80 km/h) for 20 minutes, or slightly longer in frigid temperatures.

Engine has not been run for about 5 hours.

Prepare the necessary items and check the fluid type.

All dirt cleaned off the reservoir.

Cap removed by turning it counterclockwise.

Cap reinstalled and removed again.

You may replace the following bulbs yourself. The difficulty level of replacement varies depending on the bulb. If necessary bulb replacement seems difficult to perform, contact your Toyota dealer.

For more information about replacing other light bulbs, contact your Toyota dealer.

Preparing for light bulb replacement

Check the wattage of the light bulb to be replaced.

Turn the bulb base counterclockwise.

The air conditioning filter must be cleaned or changed regularly to maintain air conditioning efficiency.

Turn the engine switch (vehicles without a smart key system) or “ENGINE START STOP” switch (vehicles with a smart key system) off.

Open the glove box and remove the cover.

The “↑UP” marks shown on the filter should be pointing up.

If the filter is dirty, clean by blowing compressed air through the filter from the underside.

Warning: Incorrect tire inflation pressure may result in reduced fuel efficiency, reduced driving comfort and tire life, reduced safety, and damage to the drive train.

CAUTION: Keep your tires properly inflated. Otherwise, conditions such as excessive wear, uneven wear, poor handling, possibility of blowouts resulting from overheated tires, poor sealing of the tire bead, wheel deformation and/or tire separation, and a greater possibility of tire damage from road hazards may occur.

NOTICE: Be sure to put the tire valve caps back on. Without the valve caps, dirt or moisture could get into the valve and cause air leakage, which could result in an accident.

Tire inflation pressure at the recommended level

No leakage after applying soapy water to the valve

Tire inflation pressure checked when tires are cold