Komatsu Hydraulic Excavator PC450LC-8

REPLACE FUEL MAIN FILTER CARTRIDGE

After the engine has been operated, all parts are at high temperature, so do not replace the filter immediately. Wait for all parts to cool down before starting the operation.

High pressure is generated inside the engine fuel piping system when the engine is running.

When replacing the filter, wait for at least 30 seconds after stopping the engine to let the internal pressure go down before replacing the filter.

Do not bring any fire or flame close.

Be careful when opening the air bleed plug in the fuel filter head. It is still under pressure, so fuel may spurt out.

Genuine Komatsu fuel filter cartridges use a special filter that has highly efficient filtering ability. When replacing the filter cartridge, always use a genuine Komatsu part.

The parts and oil are at high temperature immediately after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the operation.

If there is still pressure remaining inside the case, the oil or plug may fly out.

Loosen the plug slowly to release the pressure.

Refill capacity: each 10.5 liters (2.77 US gal)

1. Set the TOP mark at the top, with the TOP mark and plug (P) perpendicular to the ground surface.

2. Set a container under plug (P) to catch the oil.

1. Lower the work equipment to the ground.

2. Using a grease pump, pump in grease through the grease fittings shown by arrows. (2 places)

3. After greasing, wipe off any old grease that was pushed out.

CHECK LEVEL OF BATTERY ELECTROLYTE

Carry out this procedure before operating the machine.

Do not use the battery if the battery electrolyte level is below the LOWER LEVEL line. This will accelerate deterioration of the inside of the battery and reduce the service life of the battery. In addition, it may cause an explosion.

The battery generates flammable gas and there is danger of explosion, do not bring fire or sparks near the battery.

Warning: This maintenance check requires trained personnel with PPE!

Check water pump for play in pulley, oil leaks, and water leaks

If any issues are found with the water pump, contact your Komatsu distributor for inspection, overhaul or replacement

If the engine is started frequently, have this inspection carried out every 1000 hours

Replace accumulator (for control circuit) every 2 years or every 4000 hours, whichever comes sooner

Warning: The accumulator is charged with high-pressure nitrogen gas, so mistaken operation may cause an explosion, which will lead to serious injury or damage

When handling the accumulator, always do as follows:

Accumulator handling precautions

WARNING: The parts and oil are at high temperature immediately after the engine is stopped, and may cause burns. Wait for the temperature to go down before starting the work.

When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it.

NOTICE: If the machine is equipped with a hydraulic breaker, the hydraulic oil will deteriorate much faster than during normal bucket operations.

Refill capacity: 248 liters (65.52 US gal)

Prepare a handle (for the socket wrench).

Swing the upper structure so that hydraulic tank drain plug (P) and drain plug (A) at the bottom of the pump suction tube are in the middle between the left and right tracks.

Retract the arm and bucket cylinders, then lower the boom and put the teeth in contact with the ground.

Set the lock lever to the LOCK position and stop the engine.

Remove the cap of oil filler port (F) at the top of the hydraulic tank.