Inoxpa Ball Valve A640-000652063

Ensure the valve and pipes are not under pressure

Verify that the actuator is disconnected from the compressed air

Inspect the following components for wear and damage

Record any problems found during inspection

Ensure spare replacement seals are in stock

Ensure the following seal materials are not used

Ensure EPDM is used as the seal material

Is the valve installed in a system with a CIP process?

Select the type of cleaning solution to prepare

Add 100 l of chlorine-free water

Wear rubber gloves during all cleaning procedures

Check for the presence or possible formation of potentially explosive atmospheres

Clean the external part of the valve and/or actuator to avoid excessive accumulation of dust, combustible, or explosive materials

Ensure no accumulations exceed a thickness of 2 mm

Check for absence of leaks around the valve

Ensure smooth operation of the valve

Apply suitable lubricants to the seat seal material during assembly

Record the details of the valve’s maintenance

Attach any relevant maintenance statistics for planning inspections

Ensure all equipment is in place for sterilization

Verify that no cold fluid is present in the equipment

Confirm that the equipment is not started during sterilization

Record the maximum temperature during sterilization

Record the maximum time of sterilization in minutes

Is the equipment temperature below 60°C (140°F) before introducing cold fluid?