Inoxpa Ball Valve A640-000652065

Check for any leaks in the valve

Apply lubricants suitable with the material of the seat seal

Record the maintenance activities performed

Use statistics to plan future inspections

Ensure the following seal materials are not used

Ensure EPDM is used as the seal material

Select the type of cleaning solution to prepare

Add 100 liters of chlorine-free water

Alternatively, measure 2.2 liters of NaOH at 33% concentration

Wear rubber gloves during all cleaning procedures

Check for the presence or possible formation of potentially explosive atmospheres before starting assembly and disassembly works

Clean the external part of the valve and/or actuator to avoid excessive accumulation of dust, combustible, or explosive materials

Ensure no accumulation exceeds a thickness of 2 mm

Ensure all equipment is in place for sterilization

Verify that no cold fluid is present in the equipment

Confirm sterilization with steam is applied to all equipment including the pigging

Ensure equipment is not started during sterilization

Record the maximum temperature during the SIP process

Record the maximum time of the SIP process in minutes

Ensure the valve and pipes are not under pressure

Verify that the actuator is disconnected from the compressed air

Inspect the valve and its components

Record any problems observed during inspection

Confirm spare replacement seals are in stock