Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

GEA Compressor Grasso V1800T

Create an account to install this asset package.

Maintenance Plans for GEA Compressor Model Grasso V1800T

Integrate maintenance plans directly into your work orders in MaintainX.

Initial 100 Hours Compressor Maintenance

Check settings and working of all safety devices, regulators and the running conditions

Clean oil suction filter

Replace oil discharge filter

Replace oil

Inspect solenoid valves and coils

Inspect crankcase heater

Clean crankcase

Replace suction gas filter

Inspect for alignment

Run this procedure

6000 Hourly Compressor Maintenance

Check after every maintenance job the settings and working of all safety devices, regulators and the running conditions according to the Service Instruction Manual (SIM)

Clean oil suction filter

Replace oil discharge filter

Make oil analysis

Inspect shaft seals for oil/refrigerant leakage

Inspect solenoid valves and coils

Inspect cranckcase heater

Inspect and clean suction gas filter

Inspect drive alignment

Run this procedure

30000 Hourly Compressor Maintenance

For compressors without Grasso Maintenance Monitor (GMM)

Check after every maintenance job the settings and working of all safety devices, regulators and the running conditions according to the Service Instruction Manual (SIM)

Replace oil suction filter

Replace oil discharge filter

Make oil analysis

Replace oil

Oil refreshmen (If hygroscopical oil is used replace this always after each opening of compressor or installation)

Inspect and clean housing and element of oil pump

Inspect and clean control and lubrication oil pressure regulator of oil pump

Run this procedure

12000 Hourly Compressor Maintenance

For compressors without Grasso Maintenance Monitor (GMM). Check after every maintenance job the settings and working of all safety devices, regulators and the running conditions according to the Service Instruction Manual (SIM)

Replace oil suction filter

Replace oil discharge filter

Make oil analysis

Replace oil

Inspect and clean housing and element of oil pump

Inspect and clean control and lubrication oil pressure regulator of oil pump

Inspect and measure running surfaces of connecting rods of crankshaft

Inspect shaft seals for oil/refrigerant leakage

Run this procedure

Initial 6000 Hours Compressor Maintenance

Check settings and working of all safety devices, regulators and the running conditions

Replace oil suction filter