Gast Manufacturing Air Motor 1UP-NCW-2A

MAINTENANCE - Cleaning the sound absorber

Inspect muffler for non-lubricated operation

Change muffler element to avoid excessive clogging

Disconnect air supply and vent all air lines

Flush product in a well ventilated area

Avoid using kerosene or other combustible solvents

MAINTENANCE - Automatic Lubrication

Check if the unit is fitted with an automatic inline oiler

Adjust inline oiler to feed 1 drop of oil per minute

Ensure not to overfeed oil to prevent exhaust air contamination

Ensure safety precautions are followed

Disconnect air line and muffler

Select the type of flushing solvent used

Rotate the shaft by hand in both directions for a few minutes

Wear eye protection, cover exhaust with a cloth and reconnect the air line

Restart the motor at a low pressure

Is there any trace of solvent in the exhaust air?

Operate the motor for approximately 2 hours at the maximum desired load

Measure the surface temperature of the motor on the casting opposite the pipe ports

Is the surface temperature within the normal range (not exceeding 275 degrees F/135 degrees C)?

Do not continue to operate the motor if the measured surface temperature exceeds the temperature listed on the motor

Consult with your Gast Distributor/Representative if the measured temperature exceeds the listed value

MAINTENANCE - Automatic Lubrication

Check intake and exhaust filters after first 500 hours of operation

Determine how frequently filters should be checked during future operation