Gast Manufacturing Air Motor 1AM-NCW-14

Operate the motor for approximately 2 hours at the maximum desired load

Measure the surface temperature of the motor on the casting opposite the pipe ports

Is the surface temperature within the normal range (not exceeding 275 degrees F/135 degrees C)?

Do not continue to operate the motor if the measured surface temperature exceeds the temperature listed on the motor

Consult with your Gast Distributor/Representative if the measured temperature exceeds the listed value

MAINTENANCE - Automatic Lubrication

Check if the unit is fitted with an automatic inline oiler

Adjust inline oiler to feed 1 drop of oil per minute

Ensure not to overfeed oil to prevent exhaust air contamination

MAINTENANCE - Automatic Lubrication

Check intake and exhaust filters after first 500 hours of operation

Determine how frequently filters should be checked during future operation

Select the oil type used for lubricating

SPUR AND WORM REDUCERS - Lubrication

Check the oil level in spur gear reducers stored or not operated for a period of time

Ensure gear motors have proper lubrication

Verify oil level is sufficient to prevent performance loss, damage, or failure

For horizontal operation, remove both plugs and add oil to top hole until other hole overflows

For vertical operation, fill to overflow point of upper most hole