Gast Manufacturing Air Motor 2AM-NCC-43A

Operate the motor for approximately 2 hours at the maximum desired load

Measure the surface temperature of the motor on the casting opposite the pipe ports

Is the surface temperature within the normal range (not exceeding 275 degrees F/135 degrees C)?

Do not continue to operate the motor if the measured surface temperature exceeds the temperature listed on the motor

Consult with your Gast Distributor/Representative if the measured temperature exceeds the listed value

MAINTENANCE - Automatic Lubrication

Check if the unit is fitted with an automatic inline oiler

Adjust inline oiler to feed 1 drop of oil per minute

Ensure not to overfeed oil to prevent exhaust air contamination

SPUR AND WORM REDUCERS - Lubrication

Verify lubrication requirements

Is the gear reducer stored or not operated for a period of time?

Check the oil level in the spur gear reducer

Select the operation orientation of the gear reducer

For horizontal operation, remove both plugs and add oil to top hole until other hole overflows

For vertical operation, fill to overflow point of upper most hole

Use Gast #AD220 or a detergent SAE #10 automotive engine oil for lubricating

Maintenance - Manual Lubrication

Add oil to the air motor intake port

Select the type of oil used for lubrication

Was the lubrication process completed successfully?