Conair Thermolator Temperature Control Unit IC-9kW-230V

Press any button to display the first test menu

Select the Calibration Mode menu

Apply the appropriate temperature to the control input using the thermocouple calibrator

Press the up ▲ key to begin calibrating

Wait until the control displays “don” or “bad”

Press Select to start the next calibration

Inspection of Cooling and Process Lines

Inspect the following for leaks

Were any leaks detected during inspection?

Stop the Thermolator if a leak is detected

Describe the location and nature of the leak

Repair the leak before resuming operation

Press to shut down the Thermolator

Disconnect and lock out main power to the unit

Close the electrical enclosure and restore power to the unit

Press any button to display the first test menu

Power Disconnection and Lockout

Remove the top panel of the Thermolator

Use a 1/4-inch open-end wrench to remove the three bolts holding the cap to the heater tank

Disconnect and lockout the main power

Open the electrical enclosure door by turning the screw on the front panel counterclockwise

Disconnect the wires from the heater contactor

Label the wires for correct reconnection

Remove the contactor by unscrewing it

Discard the old contactor using the proper disposal procedure