Conair Thermolator Temperature Control Unit IC-12kW-460V

Unit and Surrounding Area Cleaning

Clean the unit and the area around it

Check for and remove obstructions

Ensure air intake areas are clear

Keep the floor around the unit dry

Check the level switches in the process fluid reservoir for debris or deposits

Is flushing and cleaning the reservoir necessary?

Remove the top panel of the Thermolator

Locate the reservoir near the top of the unit

Locate the fill port at the top of the reservoir

Monitor the fluid level using the sight glass on the back of the unit

Shut off the cooling water infeed

Drain the unit of all water through the drain plugs in the rear of the unit

Remove the cooling water out feed

For closed and isolated circuit models, also remove the cooling water in feed

Disconnect and lock out main power

Remove the top and side panels of the Thermolator

Lift the top panel straight up, then lift the side panels up

Disconnect and lock out main power to the unit

Press any button to display the first test menu

Disconnect and lockout the main power

Shut off the cooling water infeed and drain the unit

Drain all water using the drain plugs located at the bottom of the unit