Burton Medical Medical Light A51W

Ensure the fixture is cool before starting the replacement process.

Verify that the power is turned off before replacing the bulb.

Use a small Phillips screwdriver to loosen the retaining screw at the pod.

Slide the bulb/socket assembly back and away from the wire retainer.

Gently wiggle the bulb to separate it from the socket.

Use gloves or a dry tissue when replacing the bulb. Pull it straight out of the socket.

Unplug the power cord before replacing fuses

Use a flat screwdriver to open the fuse holder and replace the fuse(s)

Disconnect power to the lamp circuit at the main breaker before replacing the fuse

Use a flat screwdriver to open the fuse holder and replace the fuse

Ceiling Versions 100V, 230V, 240V

Remove the ceiling dome by loosening the two set screws on the locking ring

WARNING: Maintenance Schedule Suggestion

Check friction between light head and yoke shaft

Adjust friction between light head and yoke shaft if needed

Remove the pods to access the screws holding the housing together

Use a wrench to tighten the nuts on each shaft

Rotate the light head to verify correct friction

Power off the equipment and secure it from being switched on again.

Ensure only approved cleaning agents are used

Use a soft cloth dampened with a mild detergent solution for basic cleaning of all surfaces.

For stubborn stains, use a soft cloth soaked in isopropyl alcohol.