Burton Medical Medical Light A50FL

Ensure the light is turned off and unplugged

Remove pods to access screws (if applicable)

Remove the three screws holding the top and bottom housing together

Use a soft cloth to wipe the corners and surfaces

Ensure no components inside the light head are bent or damaged

WARNING: Maintenance Schedule Suggestion

Remove top housing and clean accessible parts

Check and adjust friction between light head and yoke shaft if needed

Remove the pods to access screws

Remove the 3 screws holding the top and bottom housing together

Use a wrench to tighten the nuts

Unplug the power cord before replacing fuses

Use a flat screwdriver to open the fuse holder and replace the fuse(s)

Disconnect power to the lamp circuit at the main breaker before replacing the fuse

Use a flat screwdriver to open the fuse holder and replace the fuse

Ceiling Versions 100V, and 230V, 240V

Remove the ceiling dome by loosening the two set screws on the locking ring

Replace the fuse and re-assemble in the opposite order

Ensure the fixture is cool before replacing the bulb.

Verify the power is turned off before starting the replacement.

Use a small Phillips screwdriver to loosen the retaining screw at the pod.

Slide the bulb/socket assembly back and away from the wire retainer.

Gently wiggle the bulb to separate it from the socket.

Use gloves or a dry tissue when replacing the bulb. Pull it straight out of the socket.