Burton Medical Medical Light A53DC

Ensure the fixture is cool before replacing the bulb.

Verify the power is turned off before starting the replacement.

Use a small Phillips screwdriver to loosen the retaining screw at the pod.

Slide the bulb/socket assembly back and away from the wire retainer.

Gently wiggle the bulb to separate it from the socket.

Use gloves or a dry tissue when replacing the bulb. Pull it straight out of the socket.

WARNING: Maintenance Schedule Suggestion

Adjust spring arm tension if needed

Remove the pods to access the screws holding the housing together

Use a wrench to tighten the nuts on each shaft

Rotate the light head to verify correct friction

Ensure the light is turned off and unplugged

Remove pods to access screws (if applicable)

Remove screws to detach top housing

Use a soft cloth to wipe corners and surfaces

Ensure no components inside the light head are bent or damaged

Remove the plastic cap covering the rotating mechanism by pulling it away from the assembly.

Use a common screwdriver to adjust the screw.

Does the lighthead remain balanced when moved slightly up or down at mid-range?

Snap the plastic cap back into position.