Burton Medical Medical Light A51DC

Ensure the light is turned off and unplugged

Remove pods to access screws (if applicable)

Remove screws holding top and bottom housing together

Use a soft cloth to wipe corners and surfaces

Ensure no components inside the light head are bent or damaged

Remove the pods to access screws

Remove the 3 screws holding the top and bottom housing together

Use a wrench to tighten the nuts

Power off the equipment and secure it from being switched on again.

Ensure no cleaning fluid runs into the equipment.

Use a soft cloth dampened with the selected cleaning agent for basic cleaning of all surfaces.

Use a soft cloth soaked in isopropyl alcohol for stubborn stains, if necessary.

Ensure the fixture is cool before replacing the bulb.

Verify the power is turned off before starting the replacement.

Use a small Phillips screwdriver to loosen the retaining screw at the pod.

Slide the bulb/socket assembly back and away from the wire retainer.

Gently wiggle the bulb to separate it from the socket.

Use gloves or a dry tissue when replacing the bulb. Pull it straight out of the socket.

Remove the plastic cap covering the rotating mechanism by pulling it away from the assembly.

Use a common screwdriver to adjust the screw.

Does the lighthead remain balanced when moved slightly up or down at mid-range?

Snap the plastic cap back into position.